Research of Software Parametric Filtering and Pattern Analysis for Generator Partial Discharge Monitoring System
-
摘要: 以TA1100-78型百万千瓦核能发电机普遍配备的欧洲进口型1000pF电容耦合型局部放电在线监测装置为例,介绍目前主流宽频带发电机局部放电在线装置在新建核电厂的应用情况。通过对其离线标定方法及软硬件设计理念的综合分析,结合近年多台新建核电机组的调试启动实践,得出其软件参数滤波的一般性方法。在此基础上,根据国内外发电机典型事故局部放电图谱数据,对大型发电机电容耦合型局部放电图谱典型故障分析与定位方法进行了总结。掌握了发电机局部在线监视系统的参数调整、高频滤波及图谱分析方法。能对现场实测图谱进行处理与分析。Abstract: The paper was based on the 1000pF capacitance coupling generator partial discharge monitoring system used at Ling’aO II, Hongyanhe and Ningde nuclear power stations. The application status of the mainstream wide band generator partial discharge on-line monitoring system at present was introduced. By means of the research of off-line calibration and software-hardware design, the general method of software parametric filtering according to the commissioning and startup practice of recent several newly-built nuclear power turbine generator was obtained. Then lots of real typical partial discharge pattern data from home and board were collected and studied. The induction and summarization of typical fault analysis and location method for the 2D-partial discharge pattern was completed. This paper also supplied a reference and guidance at the area of insulation judging and fault diagnosis for newly-built and on-line unit startup and operation. we have mastered parameter adjustment of local online monitor system of electric motor, high frequency filtering and photograph analysis, process of measured photograph.
-
Key words:
- Capacitance coupling /
- Partial discharge /
- Calibration /
- Parametric filtering /
- Pattern
-
计量
- 文章访问数: 16
- HTML全文浏览量: 5
- PDF下载量: 0
- 被引次数: 0