Numerical Analysis of Flow Distribution Characteristics at Core Inlet of Small Reactor under Rolling Condition
-
摘要: 为研究摇摆条件下小型反应堆强迫循环时堆芯入口处冷却剂的流量分配特性，采用数值计算的方法，使用计算流体力学（CFD）软件STAR-CCM+建立小型反应堆模型，完成模型验证，开展摇摆条件下反应堆堆芯入口流量分配特性研究。结果表明，堆芯入口位置距摇摆轴的距离越大，摇摆幅度越大，堆芯入口冷却剂流量波动越大；长周期摇摆对流量影响较小，但随着摇摆周期减小，冷却剂流量会发生跃变。堆芯入口冷却剂分布不均匀程度随摇摆幅度的增加而增加，但对摇摆周期变化并不敏感。Abstract: In order to study the flow distribution characteristics of coolant at the inlet of reactor core during forced circulation of small reactor under rolling condition, a small reactor model is established by using CFD software STAR-CCM+ with numerical calculation method, model verification is completed, and the flow distribution characteristics at the inlet of reactor core under rolling condition are studied. The results show that the greater the distance from the core inlet to the rolling axis and the greater the rolling amplitude, the greater the coolant flow fluctuation at the core inlet. The long-period rolling has little effect on the flow, but the coolant flow will jump with the decrease of the cycle. The uneven distribution of coolant at the core inlet increases with the increase of rolling angle, but it is not sensitive to the change of rolling cycle.
-
Key words:
- Small reactor /
- Flow distribution /
- Rolling condition /
- Forced circulation
-
图 5 摇摆条件下典型位置不同时刻流量示意图
Figure 5. Schematic Diagram of Flow at Different Times at Typical Positions under Rolling Conditions
图 6 特征位置质量流量与摇摆幅度的关系
Figure 6. Relationship between Mass Flow and Rolling Amplitude at Typical Position
图 7 堆芯入口流量均方差与摇摆幅度的关系
Figure 7. Relationship between Mean Square Error of Core Inlet Flow and Rolling Amplitude
图 8 B6位置质量流量与摇摆周期的关系
Figure 8. Relationship between Mass Flow at B6 Position and Rolling Cycle
-
[1] ROHDE U, KLIEM S, HÖHNE T, et al. Fluid mixing and flow distribution in the reactor circuit, measurement data base[J]. Nuclear Engineering and Design, 2005, 235(2-4): 421-443. doi: 10.1016/j.nucengdes.2004.08.045 [2] 杜思佳,刘余,李松蔚,等. “华龙一号”反应堆本体结构CFD模型研究[J]. 热科学与技术,2017, 16(5): 411-417. [3] 黄雷,佟立丽. 压力容器下腔室冷却剂流动特性数值模拟研究[J]. 核科学与工程,2019, 39(1): 42-50. doi: 10.3969/j.issn.0258-0918.2019.01.008 [4] TONG L L, HOU L Q, CAO X W. Analysis of the flow distribution and mixing characteristics in the reactor pressure vessel[J]. Nuclear Engineering and Technology, 2021, 53(1): 93-102. doi: 10.1016/j.net.2020.07.002 [5] 杨洪建,陈德峰,李铮,等. 压水堆下腔室水力特性数值研究[J]. 哈尔滨商业大学学报:自然科学版,2014, 30(4): 446-450. [6] TAN S C, WANG Z W, WANG C, et al. Flow fluctuations and flow friction characteristics of vertical narrow rectangular channel under rolling motion conditions[J]. Experimental Thermal and Fluid Science, 2013, 50: 69-78. doi: 10.1016/j.expthermflusci.2013.05.006 [7] 王畅. 周期力场作用下矩形通道内流动传热与特性研究[D]. 哈尔滨: 哈尔滨工程大学, 2013. [8] YAN B H, YU L. The experimental and theoretical analysis of a natural circulation system in rolling motion[J]. Progress in Nuclear Energy, 2012, 54(1): 123-131. doi: 10.1016/j.pnucene.2011.07.005 [9] YU S Z, YAN C Q, WANG J J, et al. Experimental and numerical study on fluctuations and distributions of fluid temperature under rolling motion conditions[J]. Annals of Nuclear Energy, 2017, 110: 384-399. doi: 10.1016/j.anucene.2017.06.050 [10] XING D C, YAN C Q, SUN L C, et al. Effect of rolling motion on single-phase laminar flow resistance of forced circulation with different pump head[J]. Annals of Nuclear Energy, 2013, 54: 141-148. doi: 10.1016/j.anucene.2012.10.025 [11] YAN B H, ZHANG G, GU H Y. Theoretical analysis of the fluid mixing at the core inlet in rolling motion[J]. Nuclear Engineering and Design, 2012, 242: 134-142. doi: 10.1016/j.nucengdes.2011.10.058 [12] 奚坤. 反应堆堆芯入口流量分配的数值模拟[D]. 哈尔滨: 哈尔滨工程大学, 2015. [13] 毕树茂,刘余,刘卢果,等. “华龙一号”反应堆精细化全堆芯大规模CFD数值模拟研究[J]. 核动力工程,2021, 42(2): 50-54. [14] 韩旭,熊进标,程旭,等. 高压安注条件下冷管段和环腔流体混合特性的数值分析[J]. 原子能科学技术,2017, 51(8): 1387-1392. doi: 10.7538/yzk.2017.51.08.1387 [15] 王坤,董秀臣,刘海鹏,等. 小型压水堆压力容器内部三维流场计算[J]. 核动力工程,2020, 41(5): 20-23. [16] 谭长禄,张虹,赵华. 基于RELAP5的海洋条件下反应堆热工水力系统分析程序开发[J]. 核动力工程,2009, 30(6): 53-56,62. -
下载:
计量
- 文章访问数: 212
- HTML全文浏览量: 43
- PDF下载量: 31
- 被引次数: 0
