Analysis of Solutions for Cable Out-of-Tolerance in DCS Control Room of Nuclear Power Plants

YANG Lin; JIANG Zhi-wei; LIU Jian-yi; CHEN Wen

Volume 32 Issue S2

Mar. 2025

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > Nuclear Power Engineering > 2011 > 32(S2): 85-89

YANG Lin, JIANG Zhi-wei, LIU Jian-yi, CHEN Wen. Analysis of Solutions for Cable Out-of-Tolerance in DCS Control Room of Nuclear Power Plants[J]. Nuclear Power Engineering, 2011, 32(S2): 85-89.

Citation:

YANG Lin, JIANG Zhi-wei, LIU Jian-yi, CHEN Wen. Analysis of Solutions for Cable Out-of-Tolerance in DCS Control Room of Nuclear Power Plants[J]. Nuclear Power Engineering, 2011, 32(S2): 85-89.

YANG Lin, JIANG Zhi-wei, LIU Jian-yi, CHEN Wen. Analysis of Solutions for Cable Out-of-Tolerance in DCS Control Room of Nuclear Power Plants[J]. Nuclear Power Engineering, 2011, 32(S2): 85-89.

Citation:

YANG Lin, JIANG Zhi-wei, LIU Jian-yi, CHEN Wen. Analysis of Solutions for Cable Out-of-Tolerance in DCS Control Room of Nuclear Power Plants[J]. Nuclear Power Engineering, 2011, 32(S2): 85-89.

PDF( 267 KB)

Analysis of Solutions for Cable Out-of-Tolerance in DCS Control Room of Nuclear Power Plants

China Nuclear Power Engineering Co. Ltd., Shenzhen, Guangdong, 518124, China

Received Date: 2011-09-26
Rev Recd Date: 2011-11-08

Available Online: 2025-03-08

Abstract

Abstract

The reasons and potential risks of cable out-of-tolerance,which happened in CPR1000 DCS control room,are analyzed in this paper.And optimization of the civil structure,I/O list distribution,equipment structure and layout,cable character selection,and trunk cable design are also introduced,and the advantages and disadvantages of the above mentioned solutions are analyzed.
- Digital control system,
- Cable out-of-tolerance,
- Optimization of civil structure,
- Trunk cable design,
- China pressurized-water reactor 1000

FullText(HTML)

References(0)

References

Relative Articles

[1]	Shu Xiangting, Yang Zhang, Xu Yizhe, Jiang Yanlong. Fault Diagnosis of Vibration Induced by Fluid of 100D Main Pump for CPR1000 Unit[J]. Nuclear Power Engineering, 2021, 42(3): 183-188. doi: 10.13832/j.jnpe.2021.03.0183
[2]	Yang Yuqi, Wang Yuan, Xiong Guohua, Wang Hongtao, Guo Yongfei. Diversity Assessment Method and Its Application in I & C System of Offshore Small Modular Reactor[J]. Nuclear Power Engineering, 2019, 40(2): 68-73. doi: 10.13832/j.jnpe.2019.02.0068
[3]	Li Changzheng, Lin Shaofang, Liu Weichao, Cai Zhiyi, Nie Lihong, Deng Yongjun. Optimization of Power Ramp Rate in CPR1000 Reactor Restarting[J]. Nuclear Power Engineering, 2019, 40(5): 74-78.
[4]	Zhang Jin, Wan Zhijian, Li Jiakang, Dong Yiling, Deng Xiaoyun, Liu Pan. Analysis of PSI Defect Problem of CPR1000 Reactor Pressure Vessel[J]. Nuclear Power Engineering, 2017, 38(1): 99-103. doi: 10.13832/j.jnpe.2017.01.0099
[5]	Liu Ying, Yang Ming. Evaluation of Nuclear Safety-Critical Software Reliability of DCS[J]. Nuclear Power Engineering, 2016, 37(1): 143-147. doi: 10.13832/j.jnpe.2016.01.0143
[6]	Liang Bo, CHeN Liping, Wang Shuai. Comparison of Fire Protection Design at Pressurized Water Reactor Nuclear Power Plant[J]. Nuclear Power Engineering, 2014, 35(S1): 80-84.
[7]	Yang Ming, Song Mengchu. Study on Quantitative Software Reliability for Digital Control System[J]. Nuclear Power Engineering, 2014, 35(S1): 54-58.
[8]	Yang Xiaohua, Liu Chaohui, Chen Zhi, Liu Jie, Wu Zhiqiang. A Merged-System-Status Monitoring Mechanism in NPP Digital Control System[J]. Nuclear Power Engineering, 2014, 35(3): 138-141. doi: 10.13832/j.jnpe.2014.03.0138
[9]	Si Hengyuan, Hu Jian, ZhONG Bin. Discussion on Method of System I＆C Classification of CPR1000 Nuclear Power Plants[J]. Nuclear Power Engineering, 2014, 35(1): 113-116.
[10]	TAN Lei, LUAN Zhenhua, YANG Zongwei, LI Xianmin, TANG Bihui. Bumpless Switching of PID-controller for CRP1000 Nuclear Power Station[J]. Nuclear Power Engineering, 2013, 34(S2): 27-30.
[11]	LIU Pei, LIU Yu, YAO Bing, DAI Bo. Analysis of Radwaste Treatment Localization Scheme at Nuclear Power Plants[J]. Nuclear Power Engineering, 2013, 34(5): 149-153.
[12]	BAO Yongke, TIAN Kuo, WANG Langlang. Root Reason and Solution Research of ASG TDFP Steam Inlet Isolating Valve Failure to Open[J]. Nuclear Power Engineering, 2013, 34(S2): 73-76.
[13]	CHEN Liang. Optimization of Anti-Dilution Protection Realization Optimize for CPR1000[J]. Nuclear Power Engineering, 2013, 34(S2): 90-92.
[14]	LI Quan-bing, ZHANG Xing-hui, REN Hong-bing, ZHU Ling-ju, DUAN Yuan-gang. Research on 90° Elbow Structure Optimization for Main Coolant Piping of CPR1000 Nuclear Power Plant[J]. Nuclear Power Engineering, 2013, 34(6): 31-35.
[15]	XIONG Guangming, DUAN Yuangang, DENG Xiaoyun, TAN Yu, JIN Ting, YANG Nengren. Numerical Simulation Research on C-ring of CPR1000 Reactor Pressure Vessel[J]. Nuclear Power Engineering, 2012, 33(6): 9-12.
[16]	ZHENG Weizhi, LI Xiangjian. Study on CPR1000 Protection System Design[J]. Nuclear Power Engineering, 2012, 33(6): 21-26.
[17]	CHEN Xing, ZHANG Shishun, LIN Jiming. Assessment of In-Vessel Corium Retention in CPR1000[J]. Nuclear Power Engineering, 2011, 32(3): 6-9,24.
[18]	WU Xiang-yong, LI Yi, LU Qin-wu, LUO Ya-lin, MAO Jie, LI Zhen. Research and Development of Module 3D Design System Based on PDMS[J]. Nuclear Power Engineering, 2011, 32(S2): 127-132.
[19]	LIN Jiming, CHEN Peng, ZHANG Shishun. Study of Containment Over-Pressure Fragility Curve and Analysis of Opening Pressure for Containment Filtration and Exhaust System[J]. Nuclear Power Engineering, 2011, 32(3): 10-14.
[20]	ZHANG Ya-pei, TIAN Wen-xi, QIU Sui-zheng, SU Guang-hui. Analyses on Flow Instability of Passive Residual Heat Removal System for CPR1000[J]. Nuclear Power Engineering, 2011, 32(6): 38-41.