Analysis on Problem of Difference between Non-Destructive Examination in Manufacturing and Pre-Service Inspection for CPR1000 Reactor Pressure Vessel

Li Jiakang; Liu Yi; Zhang Jin; Liu Feihua; Qiu Zhensheng; Dong Yiling

doi:10.13832/j.jnpe.2017.03.0077

Volume 38 Issue 3

Feb. 2025

Turn off MathJax

Article Contents

Article Navigation > Nuclear Power Engineering > 2017 > 38(3): 77-80

Li Jiakang, Liu Yi, Zhang Jin, Liu Feihua, Qiu Zhensheng, Dong Yiling. Analysis on Problem of Difference between Non-Destructive Examination in Manufacturing and Pre-Service Inspection for CPR1000 Reactor Pressure Vessel[J]. Nuclear Power Engineering, 2017, 38(3): 77-80. doi: 10.13832/j.jnpe.2017.03.0077

Citation:

Li Jiakang, Liu Yi, Zhang Jin, Liu Feihua, Qiu Zhensheng, Dong Yiling. Analysis on Problem of Difference between Non-Destructive Examination in Manufacturing and Pre-Service Inspection for CPR1000 Reactor Pressure Vessel[J]. Nuclear Power Engineering, 2017, 38(3): 77-80. doi: 10.13832/j.jnpe.2017.03.0077

Citation:

Li Jiakang, Liu Yi, Zhang Jin, Liu Feihua, Qiu Zhensheng, Dong Yiling. Analysis on Problem of Difference between Non-Destructive Examination in Manufacturing and Pre-Service Inspection for CPR1000 Reactor Pressure Vessel[J]. Nuclear Power Engineering, 2017, 38(3): 77-80. doi: 10.13832/j.jnpe.2017.03.0077

PDF( 259 KB)

Analysis on Problem of Difference between Non-Destructive Examination in Manufacturing and Pre-Service Inspection for CPR1000 Reactor Pressure Vessel

doi: 10.13832/j.jnpe.2017.03.0077

China Nuclear Power Engineering Co. Ltd., Shenzhen, Guangdong, 518172, China

Received Date: 2016-08-17
Rev Recd Date: 2016-12-30

Available Online: 2025-02-09

Abstract

Abstract

Through the analysis on the requirements of RCC-M and RSE-M,the paper comprehensively describes the difference between the non-destructive examination in manufacturing and pre-service inspection.The technical improvement scheme is proposed in terms of the inspection extent,scanning direction,recordable condition and acceptance criteria,in order to solve the engineering problem of the different inspection results caused by different technologies used in manufacturing examination and pre-service inspection.
- CPR1000,
- Reactor pressure vessel,
- Non-destructive examination in manufacturing,
- Pre-service inspection,
- Difference